#Stans iron cross weight pro

We gave more weight to MVP awards for this reason – to help identify how dominant the player was versus his peers in his best seasons. As is always the case, we tried to balance the rankings between longevity and dominance to get a good cross-section. So great players like Stan Musial and Pete Rose, who played a lot of first but are better known for another position, were excluded from consideration (though they may reappear in the Top Ten Outfielders!).Īs usual, we relied on a variety of value-based metrics in the evaluation process, including several different WAR ratings from both Baseball-Reference and Fangraphs. Our aim with this list was to keep it to players known as being first basemen first and foremost. Many great players have shifted to first base at some point in their career – usually the latter half. First base is replete with star sluggers from every generation, so before we dig into the list, let’s review how we compiled it. After all, it wouldn’t make much sense to start at third. First up on the infield is, well, first base. Thus far, we’ve revealed the top ten pitchers and catchers of all time, and this week we’ll shift to the infield as we go around the horn. On tubeless setups I run the lowest pressure I can get away with, without folding the tire over, which ends up being right around 40F/45R on the MXPs (I was around 295lbs last race season).Welcome to another edition of Top Ten. When I set tire pressure with tubes, I run the lowest I can get away with, without flatting which is around 40psi front/45 rear for CX tires.

Grip and ride quality were still much improved, it just reminded me of my tubeless MTB conversions years ago before manufacturers started shipping tubeless tires with thicker sidewalls. Only gripe I had was that I had to run similar pressures to what I ran with tubes since the sidewalls were so thin on the MXPs (I'm also a certified clydesdale, YMMV). The mold builder dries in each ridge and makes an airtight seal to the rim wall.ĭidnt have a problem for the rest of the season. Solution was to break each bead, paint a line of latex mold builder onto the bead and reseat the beads. The bead locked into place easily but the ridges along the bead allowed air to leak down, resulting in a flat tire after just a few hours. Sealant was some homebrew stuff, most recent recipe on the MTBR open-source sealant thread. I raced half of the last season on tubeless MXPs installed on Pacenti TL28 rims. We've been using Maxxis Mud Wrestlers and Specialized 2bliss Triggers / Terras with excellent results, grip and handling even at low-20s psi. They'll start out fine, and eventually work loose and start leaking / burping sealant.Ĭlements all have a ridged / textured bead on their clincher tires, so we avoid them. Not to mention Clement have a very supple casing and a Kevlar / aramid bead that will stretch and deform over time. If it's not, then no amount of sealant or tight rim fit will guarantee you won't have problems, especially at lower pressures when cornering hard.

If it's smooth with no burrs or mold marks, fine, knock yourself out, it should work (depends on rim of course but the smoother the bead, the better).

#Stans iron cross weight pro

We stick to using their sewups and look elsewhere for tubeless clinchers.Ī pro wheel guy at the shop whose advice I trust told me this: regardless of what tire you're considering using for a tubeless conversion, look closely at the tire bead. Stans does not recommend them for starters. We did not elect to convert our Clements to tubeless for CX even tho we have them as a sponsor. I've heard mixed advice about Clement and tubeless.